 |
Super High Capacity (576 Watt-hour) Multi Output Voltages ( 12V/15V/16V/18V/19V/20V/24V ) Battery Pack with UPS (Uninterrupted Power Supply) Function
This UPS system is very simple to use, just connect battery AC charger and output cable to battery with supplied special charge port adapter like picture below. The system can support uninterrupted DC power up to 90W continues output.
The battery AC Charger can supply maximum 4 Amps current, which can fully charge battery from empty in around 7 hours when not using battery. When using battery, the power AC charger will directly pass the power to battery output and at same time use rest power to charge battery. When power demanding is more than AC charger can supply, the battery will provide rest power to meet power demanding.
The battery can supply 90W power up to 6 hours when AC power is out of power.
Charger Port Special Adapter:
Plug the charge port special adapter to battery charge port, it will look like this:
Battery output connection cable with On/Off switch:
Connect output cable to one of 5.5 x 2.5mm Female output port on charger port adapter. Connect charger to another 5.5 x 2.5mm female port.
Battery Features:
24V advanced high-power Lithium Ion battery.
Important: This battery is designed for independent use only. Do not connect this battery with another battery directly in serial or parallel. Connecting this battery with another battery may damage the battery's safety protection and power management circuit board.
Features:
Built-in charge and equalizing protection board to prevent battery from over-charging
Remarkably low self-discharge for extended storage periods up to 2 years.
More than twice the service life of conventional lead acid batteries
No corrosive liquids, nor toxic heavy metals make the Li-On batteries environmentally friendly
Super lightweight: only 3.3 kg (7.3 pounds), less than the 1/4 weight of a similar lead acid battery.
Package comes with two output terminal posts:
If you need large power ( more than 6 Amps) from battery, please get power from output terminals.
Specifications:
Battery Type
|
Lithium Ion
|
Nominal Output Voltage
|
24V
|
Output Voltage Range
|
20V ~ 29.7V
|
|
Capacity
|
- 576 Watt-hour ( 24Ah @ 24V)
|
|
Maximum Continuous Discharge Current
|
|
|
Maximum Burst Discharge Current
|
|
|
Size
|
- 180 x 170 x 75 mm ( or 7" x 6.8" x 3")
|
|
Weight
|
|
|
Operate Temp. Charge
|
|
|
Operate Temp. Discharge
|
|
|
Storage Temp.
|
|
|
Cycle Life
|
|
|
PCB Safety Function
|
- Cell balancing
- Over-discharge
- Over-current protection
- Over-charge
- Temperature protection
- Secondary protection
|
AC Chargers:
Battery comes with a 29.4V 4A AC Charger Package:
Charger Dimensions: 7" x 3" x 1.5". Weight: 1.1 lb.
It can fully charge the battery in around 6 ~ 7 hours.
When using this charger, the battery can still output power while it is charging.
This battery output terminals are separated from charge port. Charge battery from charge port only. Do not charge the battery from output terminals. The charger will control charging voltage and current. Internal circuit will provide over charge and over discharge protection, but will not control charge voltage and current.
Optional Carry Bag:
You may order the battery with a carry bag if you need to carry it around.
Battery Output Voltage:
This battery output voltage range is 21V ~ 29.5V. When the battery is fully charged, its output voltage is 29.5V. The output voltage will drop gradually during the discharge process and the final cut off voltage is 21V:
2. Use this battery with DD90X DC to DC converter to provide different voltages
This battery output voltage range is 21V ~ 29.5V. This output voltage can be converted to different voltages to meet different needs by using optional BiXPower DD90X DC to DC power converters.
DD90X Power converter can connect to battery with enclosed connection cable that has an on/off switch to provide regulated output voltage.
This DD90X DC to DC power adapter can convert battery power to 12/15/16/18.5/19.5/24v voltage DC output power for laptop/notebook computers, tablet computers or other devices.
It can also provide 5V USB port power for smart phones such as iPhones (USB power cable not included)
This DC power adapter can accept 10V ~ 30V DC power, it can be used with many of our BiXPower 12V, 16V, 19V and 24V batteries.
Set DC Output Voltage
This adapter has an output voltage selection switch on side. Please refer to the electronic device you are powering to determine correct voltage. It should be marked on the DC input jack. You may also refer to the manual to determine the proper voltage setting. If there is a discrepancy between the battery chart and the setting marked on your electronic devices, ALWAYS select the voltage close to it. For example, if your laptop DC input requirement is 19.5V, you can set at 19V first, then if it does not work, set at 20V.
Caution: Please set the output voltage before connecting power adapter to input & output. If you need to change the output voltage, please disconnect the power adapter from both input & output first. Do not change the output voltage when the power adapter is connected to input power source or output device. If the power adapter stops working, disconnect it from both input and output and check if there is anything wrong with the connection.
Technical Specifications:
- Acceptable Input DC Voltage: 10V - 30V
- Efficiency >88%(TYP)
- Selectable Output Voltages:
5V/12V/15V/16V/18V5/19.5V/24V (±5%@ typical±0.8V)
- Maximum output power: 90W
- Over Load Protection
(Over current & Over Voltage Protection)
* : Yes.
Auto recovery time: 10 seconds.
- Short Circuit Protection: Yes
- Storage Temperature: -10℃ to 60℃
- Operating Temperature: 0℃ to 40℃
- Storage Humidity: 10% to 90%
- Operating Humidity: 20% to 80%
- Weight 0.55 lb (260g )
- Dimension 4.5” x 2” x 1.2” (110 x 50 x 30 mm)
- Color Black
Optional Connector Tips:
If this connector does not fit your device, you can use BiXPower C series connector tips to change it to many different size connectors.
Safety Guide
Do not disassemble the battery pack..
Do not puncture, drop, crush, throw, hit, open, or modify the battery.
Do not let water getting inside the battery.
Do not insert any foreign object into the Output and In port.
Do not expose the battery to heat above 60°C (140°F) or incinerate the battery.
Keep the battery away from children.
Always dispose of used batteries in accordance with local regulations.
If this battery is misused or abused, it can result in personal injury from heat, smoke, fire or explosion.
Obtain approval of airlines or courier companies before traveling with or shipping this battery pack.
Charging: Only use the chargers supplied with the battery or BiXPower authorized chargers to charge the battery. Chargers with incorrect voltage, current, or polarity settings may damage the battery. Please monitor the charging process and react to potential problems that may occur. If you cannot, please make sure to leave it on an isolated fireproof area, away from other flammable materials.
Storage & Handling: DO NOT leave a fully exhausted battery on a shelf. Charge it to least at 50% or more if you do not need to use it for a long time. Do not leave the battery dormant for long periods of time. We recommend using the battery at least once a month. If a battery has not been used for a long period of time, please perform the new battery exercise. Fully discharge and then fully charge the battery at least once every 3 months. Always store the battery in a cool and dry place between 0°C (32 F) and 20°C (70°F), and away from flammable materials.
Fire/Smoke Emission: Batteries contain flammable/combustible material that can be ignited, explode, release toxic materials, cause burns or give off gases when heated or in contact with sparks or flames. In the event of fire, vapor releases, and/or smoke emissions, evacuate the immediate area of all unnecessary personnel.
Package Contents:
Battery x 1
DD90X DC Power Adapter x 1
Battery AC Charger x 1
Connection cable with On/Off switch: x 1
Charge power adapter: x 1
Cautions: Please
use the BiXPower authorized charger with correct setting to charge the battery
only.
|
|
|